The training takes place at our company headquarters in Leżajsk. Its purpose is to provide basic preparation for the tuner position.
We do not teach software modification.
After completing the training, there is an opportunity to establish cooperation.
       
The information gained is essential for starting work on programming controllers.
The duration of the training is approximately 3-5 hours, during which the following topics will be discussed:

Types of Engine Controllers Used in Vehicles

• Correct identification of the controller.
• Information about the controller
• Methods for reading original software
• Programming procedures
• Devices for programming controllers

The possibilities offered by software editing are immense, here are a few:

• Chip tuning
• Optimization / repair of controller software from other companies
• Improvement of starting doses
• Removal of particulate filters FAP and DPF
• Activation of particulate filters FAP and DPF
• Removal of SCR AdBlue system
• Removal of EGR valve
• Removal of Lambda sensors and NOX sensors
• Removal of flaps in the intake manifold
• Removal of throttle
• Disabling EGT monitoring
• Disabling torque monitoring
• Disabling specific DTC errors
• Disabling fuel tank ventilation system
• Disabling second air pump, etc.
• And more...

After completing the training, there is an opportunity to establish cooperation.

Training date:
July 29, 2022, at 12 PM
Location:
V-Tuning Adam Majcherczyk
ul. Burmistrzów Zawilskich 37
37-300 Leżajsk
Contact:
Phone: +48 17 242 70 25
Phone: +48 604 913 772
Number of spots: 4
Cost: 1500 EUR

Training date: August 26, 2022
Number of spots: 4
Cost: 2000 EUR

Training date: 2xxxxx
Number of spots: 4
Cost: 2000 EUR